Dialing in a hand-crank cast-iron grain mill for fresh flour

Short answer

Use a single loose pass for cracked feed or coarse grits, and a two-pass grind (crack first, tighten second) for smooth whole-wheat baking flour without binding the burrs.

Mounting solidly saves half your effort

Clamp the cast-iron body onto a thick butcher block, sturdy workbench, or scrap 2x4 spacer block so the crank arc clears the counter edge cleanly. A flexing card table wastes arm energy on every revolution.

Two passes beat one tight pass

Beginners often crank the front tension screw all the way down on whole hard red wheat, making the handle stiff and heating the burrs. Back the wing nut off until berries crack into coarse meal, then tighten until the burrs whisper lightly and run the cracked meal through a second time (about 4 minutes per pound).

Dry-only maintenance

Brush flour dust out of the flutes with a dry pastry brush after each session. If you grind slightly oilier grains like oats, finish with a half-cup of dry uncooked white rice to polish the plates clean without ever exposing cast iron to dishwater.